kamalblogs: Vertical Selection in X++ Editor in Dynamics Ax

[gl00mie]

"Жмем Alt-O и выделяем вертикальный блок" - где ж ты раньше был?! Оказывается, эта возможность даже в 3-ке есть...

[casperkamal]

Hi Gloomie,

Thanks for the comment. But was not able to understand your comment through translators w..can you translate so that i can answer it ?

[Poleax]

Цитата:

Сообщение от gl00mie

"Жмем Alt-O и выделяем вертикальный блок" - где ж ты раньше был?! Оказывается, эта возможность даже в 3-ке есть...

Не забываем назад переключится Shift - O

[casperkamal]

Цитата:

Не забываем назад переключится Shift - O

@Poleax I don't think Shift + O is required to switch it off .....

@Kashperuk
Thanks Kashperuk. Very well understood.
I just made it a trial post to see how posts with video works..
moreover lot of programmers i have interacted haven't picked it up (Alt + O)...so just thought would do that....
will help beginners

[gl00mie]

Цитата:

Сообщение от kashperuk

Just to clarify, for casperkamal's sake: There is always a lot of sarcasm on this forum, whenever a "well-known" AX feature is "re-discovered".

Well I must mention there was no sarcasm in my comment. I've been using Far Manager's internal editor for years for some X++ code editing - just to work with vertical blocks (and to work with Perl-like regular expressions, and... well, never mind).

Цитата:

Сообщение от casperkamal

lot of programmers i have interacted haven't picked it up (Alt + O)...so just thought would do that... will help beginners

Thanks a lot! Now MorhpX code editor doesn't look that hopeless compared to others

[oip]

Цитата:

Сообщение от gl00mie

"Жмем Alt-O и выделяем вертикальный блок" - где ж ты раньше был?! Оказывается, эта возможность даже в 3-ке есть...

Gustav: Unsorted, или Записки DAX-дилетанта - II А еще это есть по-крайней мере в Inside Microsoft Dynamics AX 2009 на 70 странице. А в Inside Microsoft Dynamics 4.0 почему-то написано Ctrl+O. Или это был сарказм?

For casperkamal: I wrote that this Alt+O combination is mentioned in the Inside Microsoft Dynamics AX 2009 book on the 70th page. But in the Inside Microsoft Dynamics 4.0 book it is written that this combination is Ctrl+O.

Цитата:

Сообщение от casperkamal

Hi Gloomie,,
Thanks for the comment. But was not able to understand your comment through translators w..can you translate so that i can answer it ?

He wrote smth like "Wow, why didn't you tell this earlier?! It seems it is working even in DAX 3.0."